====== ConnMan ======

[[https://01.org/connman|ConnMan]] is a command-line network manager designed for use with embedded devices and fast resolve times. 

Although AGL Settings application provides a GUI for connecting to WiFi networks, in certain cases it could be necessary to do it from the command-line with ConnMan.

==Networking configuration==

===Connecting to a Wi-Fi network===
Follow the steps below to connect to a secured Wi-Fi network:
  * Enter connman CLI

    $ connmanctl

  * Enable Wi-Fi (only if it is not enabled)

    connmanctl> technologies
    connmanctl> enable wifi

  * Scan for W-Fi networks:

    connmanctl> scan wifi

  * List the found and available Wi-Fi networks (write down the wireless network service with format like **wifi_<MAC_ADDR>_<SSID_HEX>_managed_psk**:

    connmanctl> services

  * Turn on agent and connect to a Wi-Fi network

    connmanctl> agent on
    connmanctl> connect wifi_<MAC_ADDR>_<SSID_HEX>_managed_psk

  * If the network is secured the agent will prompt you to enter a password:

    Agent RequestInput wifi_<MAC_ADDR>_<SSID_HEX>_managed_psk
    Passphrase = [ Type=psk, Requirement=mandatory ]
    Passphrase?

===Setting up a static IP address===
Follow the steps below to configure a static IP address:
  * Retrieve the interface you want to modify (the format is **ethernet_<MAC_ADDR>_cable**):

    $ connmanctl services

  * Manually configure IP:

    $ connmanctl config <service> --ipv4 manual  <ip address> <netmask> <gateway>
    
==See Also==
  * [[https://wiki.archlinux.org/index.php/ConnMan|ArchWiki: ConnMan]]
  * [[https://wiki.tizen.org/IVI/ConnMan_Tips_&_Tricks|ConnMan Tips & Tricks]]